Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Laurel, MS

Opener Gear & Sprocket Replacement in Laurel, MS

Stripped drive gears replaced so the motor moves the door again. Typical cost $125-$275.

Opener Gear & Sprocket Replacement is one of the most common calls we get. A technician will explain what is wrong and what it will cost before starting, and test the door before leaving. Stripped drive gears replaced so the motor moves the door again.

Signs you need opener gear & sprocket replacement

  • The motor hums or runs but the chain or belt doesn't move
  • Grinding from inside the opener
  • Plastic shavings under the motor

Common causes

  • A heavy, out-of-balance door wearing the gear
  • Age and wear on the nylon gear

Safe checks before you call

  • Check the door's balance first. A heavy door will strip a new gear too.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our opener gear & sprocket replacement process

  1. Check the door's balance and springs
  2. Open the motor head and replace the gear and sprocket
  3. Grease the new gear
  4. Re-set the limits and force
  5. Test it through several cycles

Opener Gear & Sprocket Replacement cost in Laurel, MS

$125-$275Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Drive type: chain, belt, screw or wall-mount
  • Whether the fix is a part or a whole new opener
  • Remotes, keypads and smart accessories
  • Ceiling height and rail extensions

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Laurel, MS and nearby towns

A closed garage in a Mississippi summer gets very hot, which shortens the life of opener circuit boards, capacitors and photo-eye sensors. Storms add power surges, so a surge protector is cheap insurance.

Technicians serve all of Laurel (ZIP codes 39440, 39441, 39442 and 39443), plus Ellisville (7.3 mi), Petal (25.2 mi), Collins (25.2 mi) and Hattiesburg (27 mi). Call (833) 435-8883 to book a visit in Laurel.

Opener Gear & Sprocket Replacement: frequently asked questions

How much does opener gear & sprocket replacement cost in Laurel, MS?

Opener Gear & Sprocket Replacement typically costs $125-$275 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do opener gear & sprocket replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is opener gear & sprocket replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Mississippi or Laurel requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my opener?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the opener is near the end of its life, replace it. Most openers last 10 to 15 years. If yours is older than that, lacks photo eyes or rolling-code security, or needs a logic board or motor, a new opener is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Laurel, MS

Midland Garage Door Extension Spring Replacement

Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Typical $150-$350

Remote & Keypad Programming

Remotes, keypads and car buttons matched and programmed to your opener.

Typical $50-$150

Overhead Door Garage Door Opener Repair

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $125-$350

Martin Door Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Craftsman Remote & Keypad Programming

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $50-$150

Richards-Wilcox Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Skylink Garage Door Sensor Repair

Skylink makes openers and a wide range of universal replacement remotes and keypads.

Typical $100-$250

Martin Door Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

McKeon Door Rolling Steel Door Repair

McKeon makes rolling fire doors, fire curtains and rolling steel doors.

Typical $300-$1,500

Overhead Door Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Hörmann Torsion Spring Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $200-$450

Hörmann Garage Door Panel Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $300-$900

Garage door stuck, noisy or broken?

Talk to a garage door technician in Laurel, MS now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote